Help CenterInstructions
NOTE: Before you begin, please make sure the kitchen printer is switched off and both the power and Ethernet cable are unplugged from the kitchen printer.
To access the DIP switches in the OPT-KP150 kitchen printer, you will need a #2 Phillips screwdriver. You will then need to remove the two screws at the back of the printer, shown below.
Once the screws are removed, carefully remove the I/O plate. You may need to use a small flathead screwdriver to pry off the I/O plate.
Once the I/O plate is removed, you will then see the DIP switches inside the printer.
Below are the DIP Switch Settings table, and are marked accordingly.
Main DIP Switch Settings
| DIP-8 | Function | ON | OFF |
|---|---|---|---|
| SW-1 | Select Cutter | YES | NO |
| SW-2 | Kitchen Beeper | YES | NO |
| SW-3 | RESERVED | N/A | N/A |
| SW-4 | Print Width | 72 mm | 48 mm |
| SW-5 | Select Print Density Bit | See Setting Below | |
| SW-6 | Select Print Density Bit | See Setting Below | |
| SW-7 | Select Baud Rate Bit | See Setting Below | |
| SW-8 | Select Baud Rate Bit | See Setting Below | |
Print Density Selection
| SW-5 | SW-6 | Density |
| ON | ON | Dark |
| ON | OFF | Middle Dark |
| OFF | ON | Middle Light |
| OFF | OFF | Light |
Baud Rate Selection
| SW-7 | SW-8 | Baud Rate |
| ON | ON | 9600 |
| OFF | ON | 19200 |
| ON | OFF | 38400 |
| OFF | OFF | 115200 |
Once the changes are made, carefully replace the I/O plate back onto the printer. Once the I/O plate is back into place, re-install the two screws, one at each side, and secure the I/O plate.
Verify and test the printer and ensure it is at the desired settings. If you need to make further adjustments, repeat the process of removing the I/O plate.
If you need additional technical assistance relating to any of our Optima Hardware or Software products, please contact Optima Support.
Toll-Free: 1-888-475-2767
Email: possupport@optimagopos.ca